| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
| 3. |
Disconnect the door mood lamp connector. |
| 4. |
Remove the door mood lamp (A).
|
| Installation |
| 1. |
Install the door mood lamp and connector. |
| 2. |
Install the front door trim. |
| 3. |
Connect the negative (-) battery terminal. |
Overhead Console Lamp Repair proceduresInspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch...
Hazard Lamp Switch Repair proceduresInspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. AVN typeAudio typeNoDescription NoDescription 1GND1GND 2CAN _ High 2-3CAN _ Low 3- 4- 4-5Detent 5Detent 6ACC6Acc 7Battery (+)7Battery (+)8PAB Off 8PAB Off 9- 9Illumination (-)10- 10Illumination (+) 11SBR _ PS 11SBR PS 12- 12- 13Hazard lamp switch 13Hazard lamp switch 14- 14- 15IGN (+)15IGN (+)16- 16- Removal • Wrap the protective tape on the tool to disassemble with the screwdriver or remover...
Inspection 1. Check for resistance between terminals in each switch position (LH). [LH : Audio + Hands free] SwitchConnector TerminalResistance(±5%)SEEK Up4-5430 ?SEEK Down1.11 k?MUTE3.11 k?Volume (+)4.61 k?Volume (-)6.81 k?Voice10.71 k?SEND18...
Front Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body B * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body C * These dimensions indicated in this figure are actual-measurement dimensions...