Hyundai Sonata: Front Bumper / Front Bumper Cover Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Loosen the front bumper upper mounting clips.

2.	Loosen the front bumper lower mounting clips.

After loosening the front bumper (A) side's mounting clips and screw, then disconnect the side's.

•	Remove the front bumper by pulling up the side of the front bumper and then pull it out.

•	When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

4.	Disconnect the front bumper main connector (A).

5.	Remove the front bumper cover (A).

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damage clips.

Front Bumper Cover Components and Components Location

Component Location 1. Front bumper cover ...

Radiator Grill Components and Components Location

Component Location 1. Radiator grill ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Blower Unit Components and Components Location
Component Location 1. Blower unit assembly Components 1. Intake actuator2. Intake case [LH]3. Intake door assembly4. Air filter5. Filter cover assembly6. Intake inlet seal 7. Intake case [RH]8. Intake outlet seal 9. Blower upper cover10. Blower unit pad11. Blower lower case12. Resistor13 ...

Hyundai Sonata LF 2014-2019 Service Manual: Starter Specifications
Specification ItemSpecificationRated voltage12 V, 0.9 kWThe number of pinion teeth10Performance[No-load, 11.5 V]AmpereMax. 60 ASpeedMin. 5,500 rpm ...