Hyundai Sonata: Evaporative Emission Control System / Fuel Tank Air Filter Repair procedures

Replacement
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Lift the vehicle.
3.
Remove the rear-left wheel & tire and house cover.
4.
Disconnect the canister close valve connector (A).
5.
Disconnect the vapor hose (B).
6.
Remove installation bolts (A) and then remove the fuel tank air filter.

7.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

8.
Install a new fuel tank air filter.
Fuel Filler Cap Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap ...

Exhaust Emission Control System
...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Rail Pressure Sensor (RPS) Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control co ...

Hyundai Sonata LF 2014-2019 Service Manual: Starter Components and Components Location
Components 1. Screw2. Front housing3. Stop ring4. Stopper5. Overrunning clutch6. Lever7. Lever plate8. Lever packing9. Magnet switch assembly10. Armature assembly11. Yoke assembly12. Brush (-)13. Brush holder14. Brush (+)15. Rear bracket16. Through bolt17. Screw ...

© 2018-2025 www.hsonatalf.org