Hyundai Sonata: Dual Clutch Transmission Control System / Input shaft speed sensor 2 Description and Operation
| Description |
| • |
Components location : DCT (Dual Clutch Transmission)
|
| • |
Function
The input shaft speed sensor is important in that it detects
the input shaft RPM and sends this information to the Transmission
Control Module (TCM).
It provides important input information for electric control.
The information is needed in all operations, including
feedback control, gear shift control and failure detection of other
sensors. |
Input shaft speed sensor 2 Specifications
Specification
ItemSpecificationTypeHall effect sensorOperation condition (°C)°F(-40 ~ 150)-40 ~ 302Output signal (mA)High: 11.8 ~ 16.8Low: 5.9 ~ 8.4
...
Input shaft speed sensor 2 Schematic Diagrams
Circuit Diagram
...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Fuel Pump Motor Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
2.
Disconnect the electric pump wiring connector (A), and the fuel sender connector (B).
3.
Remove the reservoir-cup after releasing the fixing hook (A).
4.
Remove the fixing clip (A), and then disconnec ...
Hyundai Sonata LF 2014-2019 Service Manual: Blind Spot Detection Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
3.
Remove the BSD unit (A) after loosening the mounting nuts.
Take care not to separate the bracket from rear bumper when removing the BSD sensor.
...
