Hyundai Sonata: Warning Lights / Low Tire Pressure Warning Light
This warning light illuminates:
- Once you set the ignition switch or the Engine Start/Stop button to the
ON position.
- It illuminates for approximately 3 seconds and then goes off. - When one or more of your tires are significantly underinflated (The location of the underinflated tires are displayed on the LCD display).
This warning light remains on after blinking for approximately 60 seconds or repeats blinking and off at the intervals of approximately 3 seconds:
When there is a malfunction with the TPMS.
In this case, have your vehicle inspected by an authorized HYUNDAI dealer.
WARNING
Safe Stopping
- The TPMS cannot alert you to severe and sudden tire damage caused by external factors.
- If you notice any vehicle instability, immediately take your foot off the accelerator pedal, apply the brakes gradually with light force, and slowly move to a safe position off the road.
Low Fuel Level Warning Light
This warning light illuminates:
When the fuel tank is nearly empty.
Add fuel as soon as possible.
NOTICE
- Low Fuel Level
Driving with the Low Fuel Level warning light on or with the fuel level below ...
Automatic Emergency Braking (AEB) Warning light
This warning light illuminates :
When the AEB system is turned off.
When the radar or its cover is stained. Remove the stains with a soft cloth.
When there is a malfunction with AEB. In this case ...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Repair procedures
Repair procedures
ESP System bleeding
This procedure should be followed to ensure adequate bleeding
of air and filling of the ESC unit, brake lines and master cylinder
with brake fluid.
1.
Remove the reservoir cap and fill the brake reservoir with brake fluid.
If th ...
Hyundai Sonata LF 2014-2019 Service Manual: EPB Switch Repair procedures
Removal
1.
Turn ignition OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console assembly.
(Refer to Body - “Floor console assembly")
3.
Remove the EPB switch after loosening the screws.
4.
Install in the reverse order of removal. ...
