Hyundai Sonata: Power Door Locks / Power Door Lock Module Repair procedures

Inspection
   
Wrap the protective tape on the tool to disassemble with the screwdriver or remover.
Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
Disconnect the connector from the actuator.

No
Pin Information
LH
RH
1
AJAR Switch
Motor 2
2
COM
Motor 1
3
Lock / UnLock switch
-
4
Key Lock switch
Key Unlock switch
5
Key Unlock switch
Key Lock switch
6
-
Lock / UnLock switch
7
Motor 1
COM
8
Motor 2
AJAR switch

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Lock Module Inspection
1.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
2.
Remove the rear door module.
(Refer to Body - "Rear Door Module")
3.
Disconnect the connectors from the actuator.

No
Pin information
LH
RH
1
AJAR Switch
Motor 2
2
COM
Motor 1
3
Lock / UnLock switch
-
4
-
-
5
-
-
6
-
Lock / UnLock switch
7
Motor 1
COM
8
Motor 2
AJAR Switch

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Lock Module Inspection
1.
Remove the trunk lid trim.
(Refer to Body - "Trunk Lid Trim")
2.
Disconnect the connector from the actuator

3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

4.
Checking the trunk of the vehicle power option power refers to the trunk module.
Trunk Open Switch
1.
Disconnect the negative (-) battery terminals.
2.
Remove the trunk lid trim
(Refer to Body - "Trunk Lid Trim")
3.
Disconnect the trunk open switch assembly connector (A).

4.
Check for continuity between terminals in half latching condition according to the table.

Hood Switch
1.
Disconnect the connector (A).

2.
Check for continuity between the terminals and ground according to the table
(Refer to Body - "Hood Latch")

Power Door Lock Module Components and Components Location
Conponents 1. Door lock/unlock knob cable2. Door inside handle cable3. Door Latch ...

Power Door Lock Switch Repair procedures
Inspection Diagnosis with GDS 1. The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). The diagnostic system (GDS) provides the following informa ...

Other information:

Hyundai Sonata LF 2014-2019 Owners Manual: Wiper Blades
Blade Inspection Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers. Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping pro ...

Hyundai Sonata LF 2014-2019 Owners Manual: Severe Driving Conditions
A- Repeatedly driving short distances of less than 5 miles (8 km) in normal temperature or less than 10 miles (16 km) in freezing temperature B- Extensive engine idling or low speed driving for long distances C-Driving on rough, dusty, muddy, unpaved, graveled or saltspread roads D-Driving in areas ...

© 2018-2025 www.hsonatalf.org