Hyundai Sonata: Fuses And Relays / Relay Box (Engine Compartment) Repair procedures
1. |
Disconnect the negative (-) battery terminal. |
2. |
Pull out the relay from the engine compartment relay block. |
Power Relay (Type A)
Check for continuity between the terminals.
3) |
Head lamp (high) relay |
1. |
There should be continuity between the No.30 and No.87
terminals when power and ground are connected to the No.85 and No.86
terminals. |
2. |
There should be no continuity between the No.30 and No.87 terminals when power is disconnected.
Engine Room Relay Block |
Power Relay (Type B)
Check for continuity between the terminals.
1. |
There should be continuity between the No.30 and No.87
terminals when power and ground are connected to the No.85 and No.86
terminals. |
2. |
There should be no continuity between the No.30 and No.87 terminals when power is disconnected. |
Metal Core PCB Block
1. |
Disconnect the negative (-) battery terminal. |
2. |
Put up the metal care PCB block (A) after push 4 hooks (B) in the block assembly. |
3. |
Remove the metal care PCB block after disconnet the connector. |
Fuse
1. |
Be sure there is no play in the fuse holders, and that the fuses are held securely. |
2. |
Are the fuse capacities for each circuit correct? |
3. |
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse. |
|
Multi Fuse
Engine room fuse is to optimize the package.
- |
Multi fuse has to replace in the mass when it damaged only one fuse. |
- |
When replacing the multi fuse, refer to the "Engine compartment - component location" diagram exactly. |
- |
Use the multi fuse capacities for each circuit correctly. |
|
Component Location
[Engine room junction block]
[Metal Core Block (PCB)]
...
Component Location
[Interior Junction Block]
...