| Removal |
| 1. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover") |
| 2. |
Remove the high pitch horn (A) and low pitch horn (B) after
disconnect the horn connector (C) and loosening the mounting the bolt.
|
| Installation |
| 1. |
Install the horns after connect the horn connectors. |
| 2. |
Install the front bumper cover. |
| Inspection |
| 1. |
The relay on the horn of this vehicle is implanted into the metal core block PCB of the engine room relay block. |
The relay inserted in semi-conductor chip type on the PCB is
not available for changing. The metal core boxy shall be tested by
exchanging when the relay shall be changed. |
Audio..
Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door window glass mounting hole plug (A)...
Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...