Hyundai Sonata: Sunroof / Resetting the sunroof

Sunroof needs to be reset if the following occurs :

- Battery is discharged or disconnected or the related fuse has been replaced or disconnected
- The one-touch sliding function of the sunroof does not normally operate

Reset procedure :

1. Place the ignition switch to the ON position or start the engine. It is recommended to reset the sunroof while the engine is running.

2. Push the control lever forward. The sunroof will close completely or tilt depending on the condition of the sunroof.

3. Release the control lever until the sunroof does not move.

4. Push the control lever forward about 10 seconds.

- When the sunroof is in the close position :
The glass will tilt and slightly move up and down.
- When the sunroof is in the tilt position:
The glass will slightly move up and down.

Do not release the lever until the operation is completed.

If you release the lever during operation, start the procedure again from step 2.

5. Within 3 seconds, push the control lever forward until the sunroof operates as follows:

Tilt down → Slide Open → Slide Close.

Do not release the lever until the operation is completed.

If you release the lever during operation, start the procedure again from step 2.

6. Release the sunroof control lever after all steps have completed. (The sunroof system has been reset.)

Information

Sunshade
The sunshade will open automatically with the sunroof when the glass panel moves. If you want it closed, move the sunshade manually. NOTICE The sunroof is made to slide together with the sunshade. D ...

Exterior features
...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Front Bumper Cover Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Us ...

Hyundai Sonata LF 2014-2019 Service Manual: Rear Parking Assist System Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the rear curtain switch (A) after loosening the mounting screws. Installation 1. Install the switch assembly in the console upper cover. ...

© 2018-2025 www.hsonatalf.org