| Remove and Installation |
| 1. |
Remove the cylinder head assembly.
(Refet to Cylinder Head Assembli - "Cylinder Head") |
| 2. |
Remove the water jacket seperator (A).
|
| 3. |
Install in the reverse order of removal. |
Inspection 1. Fuse inspection Mount the test fuse to the switch fuse and relay fuse part to confirm a normal joint fit. 2. Inspection of connector by each part Check to see whether or not each connector has been damaged, or terminal surge, or incomplete connection has taken place [Engine room junction box] [Stop signal electronic module] [ABS/VDC control module] 3...
Fuel Pressure Test (Low pressure system) 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur...