Hyundai Sonata: Charging System / Alternator Description and Operation

Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.

1. Brush
2. OAD (Overrunning Alternator Decoupler)
3. Rotor
4. Stator

Repair procedures
On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...

Alternator Specifications
Specification ItemSpecificationRated voltage 13.5V, 130A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Re ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: High Mounted Stop Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear package tray trim. (Refer to Body - "Rear Package Tray Trim") 3. Remove the high mounted stop lamp after disengaging the mounting clip. Installation 1. Install the rear high mounted stop lamp. 2. Instal ...

Hyundai Sonata LF 2014-2019 Service Manual: CVVT Oil Control Valve (OCV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1. Turn the ignition switch ...

© 2018-2025 www.hsonatalf.org