Hyundai Sonata: Charging System / Alternator Specifications

Specification
Item
Specification
Rated voltage
13.5V, 130A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C?
Internal mode
-3.5 ± 2mV / °C

Alternator Description and Operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of this ...

Alternator Components and Components Location
Components 1. OAD (Overrunning Alternator Decoupler) 2. Front Bracket3. Front Bearing4. Stator5. Rotor6. Rear Bearing7. Rear Bracket8. Brush Holder Assembly9. Through Bolt10. Rectifier Assembly11 ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from ...

Hyundai Sonata LF 2014-2019 Owners Manual: Brake Fluid
Checking the Brake Fluid Level Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake fluid, clean the area around the reservoir cap thoroughly to prevent brake fluid ...

© 2018-2025 www.hsonatalf.org