Hyundai Sonata: Multimedia System / Features of Your Vehicle
Satellite radio reception
You may experience difficulties in receiving XM™ satellite radio signals in the
following situations.
- If you are driving in a tunnel or a covered parking area.
- If you are driving beneath the top level of a multi-level freeway.
- If you are driving under a bridge.
- If you are driving next to a tall vehicle (such as a truck or a bus) that
blocks the signal.
- If you are driving in a valley where the surrounding hills or peaks block
the signal from the satellite.
- If you are driving on a mountain road where is the signal blocked by mountains.
- If you are driving in an area with tall trees that block the signal (30
ft. /10m or more), for example on an road that goes through a dense forest.
- The signal can become weak in some areas that are not covered by the XM™
repeater network.
Information
There may also be additional unforeseen circumstances leading to reception
problems with the XM™ satellite radio signal.
Advisory Messages, such as 'CH Unavailable' may occur when starting XM™ Radio.
AM and FM radio signals are broadcast from transmitter towers located around
your city. They are intercepted by the radio antenna on your vehicle. This signal
is then processed by the radio and sen ...
WARNING
Carbon monoxide (CO) gas is toxic. Breathing CO can cause unconsciousness
and death.
Engine exhaust contains carbon monoxide which cannot be seen or smelled.
Do not inhale engine exhaust.
If ...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Sub Frame Repair procedures
Replacement
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the wheel cap (A).
Be careful not to damage to the wheel cap (A) when removing the it.
3.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.3 ~ 107.9 ...
Hyundai Sonata LF 2014-2019 Service Manual: Under Body Body Repair
Projected Dimensions
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ]
Actual Measurement Dimensions
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ]
Front side member tooling hole (O ...