Folding the rear seat
The rear seatbacks can be folded to facilitate carrying long items or to increase the luggage capacity of the vehicle.
WARNING
To fold down the rear seatback:
1. Set the front seatback to the upright position and if necessary, slide the front seat forward.
2. Lower the rear head restraints to the lowest position.
3. Pull on the seatback folding lever (1) located in the trunk.
4. Fold the seatback toward the front of the vehicle.
5. To use the rear seat, lift and pull the seatback rearward. Pull the seatback firmly until it clicks into place. Make sure the seatback is locked in place.
When you return the seatback to its upright position, always be sure it has locked into position by pushing on the top of the seatback.
WARNING
When returning the rear seatback from a folded to an upright position, hold the seatback and return it slowly. Ensure that the seatback is completely locked into its upright position by pushing on the top of the seatback. In an accident or sudden stop, the unlocked seatback could allow cargo to move forward with great force and enter the passenger compartment, which could result in serious injury or death.
WARNING
Do not place objects in the rear seats, since they cannot be properly secured and may hit vehicle occupants in a collision causing serious injury or death.
WARNING
Make sure the engine is off, the shift lever is in P (Park), and the parking brake is securely applied whenever loading or unloading cargo. Failure to take these steps may allow the vehicle to move if the shift lever is inadvertently moved to another position.
Hyundai Sonata LF 2014-2019 Service Manual: Start/Stop Button Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the center facia panel.
(Refer to Heating, Ventilation and Air Conditioning - "Controller")
3.
Remove the start/stop button (A) after loosening the screw (3EA).
Installation
1.
Install the start/stop button.
2.
...
Hyundai Sonata LF 2014-2019 Service Manual: TPMS Sensor Repair procedures
Replacement
1.
Remove the tire.
(Refer to Tires/Wheels - "Tire")
2.
Remove the screw with torx driver (A).
•
When installing the bead brake, make sure that it does not come in contact with the TPMS sensor.
•
Be careful not to damage the TPMS sensor whe ...