Hyundai Sonata: Seats / Head Restraints
The vehicle’s front and rear seats have adjustable head restraints. The head restraints provide comfort for passengers, but more importantly they are designed to help protect passengers from whiplash and other neck and spinal injuries during an accident, especially in a rear impact collision.
WARNING
To reduce the risk of serious injury or death in an accident, take the following precautions when adjusting your head restraints:
- Always properly adjust the head restraints for all passengers BEFORE starting the vehicle.
- NEVER let anyone ride in a seat with the head restraints removed.
- Adjust the head restraints so the middle of the head restraints is at the same height as the height of the top of the eyes.
- NEVER adjust the head restraint position of the driver’s seat when the vehicle is in motion.
- Adjust the head restraint as close to the passenger's head as possible. Do not use a seat cushion that holds the body away from the seatback.
- Make sure the head restraint locks into position after adjusting it.
NOTICE
To prevent damage, NEVER hit or pull on the head restraints.
Armrest
The armrest is located in the center of the rear seat. Pull the armrest down
by using the strap from the seatback to use it.
You will find cup holders on the center armrest.
CAUTION
Be careful whe ...
Front seat head restraints
The vehicle’s front and passenger’s seats are equipped with adjustable head restraints
for the passengers safety and comfort.
Adjusting the height up and down
To raise the head restraint:
1. Pu ...
Other information:
Hyundai Sonata LF 2014-2019 Owners Manual: Seat Belt Warning Light
Seat belt warning light (for driver's seat)
The driver's seat belt warning light and chime will come on according to the
following table when the ignition switch is in the ON position.
Seat belt warning light (for front passenger's seat)
The front passenger's seat belt warning light will activat ...
Hyundai Sonata LF 2014-2019 Service Manual: Boost Pressure Sensor (BPS) Repair procedures
Inspection
1.
Connect a GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the boost pre ...
