| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front door quadrant inner cover (A).
|
| 3. |
Disconnect the power door mirror connector from the harness.
|
| 4. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
[Mirror Control (LH/RT)]
[Puddle Lamp]
[BSD Indicator]
[Mirror Heater]
[Side Repeater Lamp]
|
| 1. |
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
|
| 2. |
Select the "Car Model' and the system to be checked in order to check the vehicle with the tester. |
| 3. |
Select the "Body Control Module (BCM)" to check the driver seat or assistant door module (DDM/ADM). |
| 4. |
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the driver seat or assistant door module(DDM/ADM) can be checked.
|
| 5. |
If you will check the power door lock operation forcefully, select "Actuation Test". |
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3. Disconnect the front fog lamp connector (A). 4. Remove the front fog lamp assembly (A) after loosening the mounting nut...
Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator Position Sensor (APS) is used to receive driver input...