Hyundai Sonata: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement
   
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear package tray trim.
(Refer to Interior Trim - "Rear Package Tray Trim")
2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[LH]

[RH]

3.
After loosening the retractor (A) mounting bolt, remove the rear seat belt (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[LH]

[RH]

4.
Install in the reverse order of removal.
   
Replace any damaged clips.
Rear Seat Belt Retractor Components and Components Location
Component Location 1. Rear seat belt retractor [LH]2. Rear seat belt retractor [RH] ...

Rear Center Seat Belt Retractor Components and Components Location
Component Location 1. Rear center seat belt retractor ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Engine Control Module (ECM) Repair procedures
Removal     When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. [In the case of installing used ECM] 1. Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group) 2. Insert the key and turn it to th ...

Hyundai Sonata LF 2014-2019 Service Manual: Repair procedures
Removal     • Put on gloves to protect your hands.     • Use seat covers to avoid damaging any surfaces. 1. Remove the roof side molding. (Refer to Body Side Moldings - "Roof Side Molding") 2. Remove the package tray trim. (Refer to ...

© 2018-2025 www.hsonatalf.org