Hyundai Sonata: Maintenance / Scheduled Maintenance Services
Follow Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, you must follow the Maintenance Under Severe Usage Conditions.
- Repeated short distance driving.
- Driving in dusty conditions or sandy areas.
- Extensive use of brakes.
- Driving in areas where salt or other corrosive materials are used.
- Driving on rough or muddy roads.
- Driving in mountainous areas.
- Extended periods of idling or low speed operation.
- Driving for a prolonged period in cold temperatures and/or extremely humid climates.
- More than 50% driving in heavy city traffic during hot weather above 90°F (32°C).
For additional information or assistance see your authorized HYUNDAI dealer.
- Normal Maintenance Schedule (Gamma 1.6 T-GDI/Theta 2.0 T-GDI)
- Maintenance Under Severe Usage Conditions (Gamma 1.6 T-GDI/Theta 2.0 T-GDI)
- Severe Driving Conditions
- Normal Maintenance Schedule (Theta 2.4 GDI)
- Maintenance Under Severe Usage Conditions (Theta 2.4 GDI)
Owner Maintenance Schedule
When you stop for fuel:
Check the engine oil level.
Check coolant level in the engine coolant reservoir.
Check the windshield washer fluid level.
Check for low or under-inflated tires.
WARNING
B ...
Normal Maintenance Schedule (Gamma 1.6 T-GDI/Theta 2.0 T-GDI)
I : Inspect : Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change.
...
Other information:
Hyundai Sonata LF 2014-2019 Owners Manual: AUTO HOLD
This feature keeps the brake applied when the shift lever is in D (Drive), N
(Neutral) or Manual shift mode with the feature enabled and when the brake pedal
has been depressed to stop the vehicle.
To apply:
1. Press the [AUTO HOLD] switch. The AUTO HOLD indicator will illuminate white
and the s ...
Hyundai Sonata LF 2014-2019 Owners Manual: BSD (Blind Spot Detection) / LCA (Lane Change Assist)
Operating conditions
To operate:
Press the BSD switch with the Engine Start/Stop button in the ON position. The
indicator illuminates on the switch. If vehicle speed exceeds 20 mph (30km/h) the
system will activate.
To cancel:
Press the BSD switch again. The indicator on the switch will go off.
W ...
